Doodling Around In ZBrush, Practicing Hard Surface Modelling, Ended Up With A Vaguely Art Deco Robot

Doodling around in ZBrush, practicing hard surface modelling, ended up with a vaguely Art Deco robot

1st print - definitely some issues, but they should be fixable with more supports.

Actual size 40mm tip-to-base

More ZBrush practice

This was a very successful learning piece.  I made MANY mistakes

If I concentrate, I should be able to avoid maybe half of them next time...

(I apologise for any nightmares caused by inadvertent trips into the uncanny valley.  Since my uncanny valley was apparently filled in and leveled off, I can’t tell)

First attempt at painting a 3D print.

Looks like I have a new desk ornament :)

Sculpted in ZBrush 2018

Printed on a Peopoly Moai at 25 micron layer height

Painted with acrylic model paints

All the parts are printed, and the first finishing pass is finally over! (so much sanding...)

Now I just need to assemble, second finish & paint!

Work in Progress of a project I’ve been working on

Still about a dozen parts still to model/print; then the epic filling/sandathon begins...